4 x 12

4 x 12 

12 x 24

12 x 24 

24 x 48 (not shown)

hex

4" Hex - Available in Natural Finish Only

hex

Herringbone - Available in Natural Finish Only


Colors, Size & Trim

Colors  
GIMABK
Black
Natural Finish Sizes - Rectified  
GIMABKN/2448 24 x 48
GIMABKN/1224 12 x 24
GIMABKN/412 4 x 12
Natural Finish Mosaic  
GIMABKN/4HX 4" Hex
GIMABKN/HB Herringbone
Lappato Finish Sizes - Rectified  
GIMABKL/2448 24 x 48
GIMABKL/1224 12 x 24
GIMABKL/412 4 x 12
Natural Trim  
GIMABKN/SBN 3 x 12 Surface Bullnose
Lappato Trim  
GIMABKL/SBN 3 x 12 Surface Bullnose

Images

Additional Information

Trim

The Surface Bullnose is made from field tile that is cut, ground and then reglazed. The rounded edge on Lappato finish GIMABKL/SBN is not fully polished.

Installation Information

Most Italian manufacturers recommend a maximum offset of 8” (20cm) on all large format tiles when setting a running bond. Please refer to ANSI requirements for setting large format tiles, ANSI A 108.2 Section 4.3.8.

Lappato Cleaning And Maintenance

The Lappato finish is suitable for walls and for residential bathroom floors. As with all shiny material, the polished surface is susceptible to scratching during installation and use, and extra care should be taken when handling and grouting.

Polished material can be etched with acids. Avoid detergents, solvents or acid-based products containing hydrochloric acid, citric acid, acetic acid or abrasive components. Do not use cleaning agents like abrasive cleaners which might scratch the surface. It is advisable to test a small area in a discreet section of the tiles before proceeding to clean the whole surface.

Usage

Gazzini Marquinia is suitable for residential applications.

Non-Stock

NON-STOCK SIZES and FINISHES are subject to minimum order quantities. Non-Stock prices are subject to change and should be reconfirmed at time of order.

italy italyitalyitaly
testing
The Coefficient of Friction is a general guide only. Testing may vary with different production runs and with different testing labs.

As noted in the American with Disabilities Act (ADA) the coefficient of friction varies considerably due to facts not under the control of entities such as the manufacturers and distributors. These factors include, but are not limited to, contaminants, slope of terrain, drainage conditions, adjacent surfaces, etc. Suitability for any installation can only be determined by a site examination of all conditions that could affect the slip resistance of the tile being installed. Continual cleaning and maintenance must be performed once the tile has been installed.