\
THIS PRODUCT IS BEING PHASED OUT. PLEASE CHECK AVAILABILITY.

luna

Bianco (CGLABO)


Colors, Sizes & Trim

Colors  
CGLABO Bianco
Sizes - Natural Finish - Rectified  
CGLABON/1224 12 x 24
CGLABON/312 3 x 12
CGLABON/22 2 x 2
Sizes - Levigato Finish - Rectified  
CGLABONL/1224 12 x 24
CGLABOL/312 3 x 12
Trim - Natural Finish - Rectified  
CGLABON/SBN 3 x 24 Surface Bullnose
Trim - Levigato Finish - Rectified  
CGLABOL/SBN 3 x 24 Surface Bullnose

Usage

Luna is suitable for residential and light to moderate commercial use.

Installation

Most Italian manufacturers recommend a maximum offset of 8” (20cm) on all large format tiles when setting a running bond. Please refer to ANSI requirements for setting large format tiles, ANSI A 108.2 Section 4.3.8. Using a leveling system can improve the installation of this product.

Levigato Cleaning and Maintenance

The Levigato finish is suitable for walls and for residential and light commercial floors that do not require DCOF. As with all glossy material, the polished surface is susceptible to scratching during installation and use, and extra care should be taken when handling the material. Polished material can be etched with acids. The Levigato finish has a protective sealer applied on the production line. In any case, it is strongly recommended to apply extra protection by using FILA PD15 or something similar. A polished floor should be washed with normal, domestic use, NEUTRAL pH detergents and plenty of warm water in order to maintain its natural shine. Beware of products that say no rinsing is necessary, as detergents should always be completely rinsed off a polished floor. Avoid non-neutral detergents, solvents, abrasive or acid-based products.

Trim

The surface bullnose is made from field tile that is cut, ground and reglazed.

Non-Stock Size

Subject to minimum order quantities.

testing

 

italy

Natural Finish

testing
The Coefficient of Friction is a general guide only. Testing may vary with different production runs and with different testing labs.

As noted in the American with Disabilities Act (ADA) the coefficient of friction varies considerably due to facts not under the control of entities such as the manufacturers and distributors. These factors include, but are not limited to, contaminants, slope of terrain, drainage conditions, adjacent surfaces, etc. Suitability for any installation can only be determined by a site examination of all conditions that could affect the slip resistance of the tile being installed. Continual cleaning and maintenance must be performed once the tile has been installed.