HOME | TILE BY MATERIAL | PORCELAIN FLOOR AND WALL TILE | APOGEO
Apogeo by Tagina


signum
made in italy

“Apogeo,” Italian for “apogee,” means the highest point of an object’s orbit. It is the perfect name for Tagina’s new line. Tile trends are cyclical, and the current trend of “return to rustic” is a natural fit for Tagina. They simply looked to their history and the products that made them famous; then using the latest technology and a contemporary sensibility, they created this new line which represents the pinnacle of their considerable capabilities. Rich colors, wide variation, and slightly chiseled edges are all characteristics of Apogeo. Multiple sizes, including a hexagon, allow endless design options. There is a lot of variation in this line which cannot be ascertained by looking at one piece. Please check tile samples before making final selections.

 

almond almond almond
Anthracite (TAAOAE) Dark Brown (TAAODB) Golden (TAAOGN)

almond
almond almond
Light Brown (TAAOLB) Old Cotto (TAAOOC) Tortora (TAAOTA)


PRODUCT INFORMATION

SIZES
7 x 7*
7 x 14*
14 x 14*
24 x 24
13” Hex•
TAAO--/77
TAAO--/714
TAAO--/1414
TAAO--/2424
TAAO--/13HX
 


 
*Note that these sizes can be used in patterns, but they are not necessarily modular with a grout joint. Many patterns can be accomplished by using a grid layout to establish the correct repeat. This should be discussed and planned with the installer before product selection.


COLORS
TAAOAE
TAAODB
TAAOGN
TAAOLB
TAAOOC
TAAOTA
Anthracite (Grey)
Dark Brown
Golden (Grey/Beige)
Light Brown (Suede)
Old Cotto
Tortora (Cream)
Note: The Golden and Tortora colors can be easily confused because the Tortora color looks more gold than the Golden.

TRIM
TAAO--/SBN 3 X 24 Surface Bullnose  
The Surface Bullnose is made from field tile that is cut, ground and reglazed.

USAGE & INSTALLATION
To attain the proper mix of graphics and color it is important to mix tile within each carton and blend tile from several cartons during installation.

Most Italian manufacturers recommend a maximum offset of 8” (20cm) on all large format tiles when setting running bond. Please refer to ANSI requirements for setting large format tiles ANSI A108.02 Section 4.3.8.


TECHNICAL INFORMATION

** These results are for the natural finish and for the normal productions; if there is concern about a particular production, it should be tested. The Coefficient of Friction is a general guide only. Testing may vary with different production runs and with different testing labs.

As noted in the Americans with Disabilities Act (ADA) the coefficient of friction varies considerably due to facts not under the control of entities such as the manufacturers and distributors. These factors include, but are not limited to, contaminants, slope of terrain, drainage conditions, adjacent surfaces, etc. Suitability for any installation can only be determined by a site examination of all conditions that could affect the slip resistance of the tile being installed. Continual cleaning and maintenance must be performed once the tile has been installed. For more information see our current handout Americans with Disabilities Act and Slip Resistance of Tile.


Back to Top


Previous Page